Hey Folks:
I built a set of these a couple of years ago. And they WORRRKKKK!!! You can track the blades, in flight, at night. You can even identify which blade needs bearing replacement.
I had 2 blades that followed the same tip bath within about 1/8". Then one blade flew 2 inches high on the advancing side and 1" low on the retreating side.
After a LOT of scratching my head and trying to figure out WHY, I just gave up. Then I sent this drawing to my friend who has a B-2. He made him a set and had almost the identical situation.
He replaced the bearings in the ONE blade that was flying erratically. Now they all three track well.
Blade Tracking LED's
Moderator: Paul Sehorne
Blade Tracking LED's
- Attachments
-
- Fabrication Drawing of Tip LED's
- leds9.jpg (209.58 KiB) Viewed 3933 times
YHO-3BR Pilots International
-
SunHelo Mark
- Posts: 18
- Joined: Tue Jan 01, 2008 10:23 am
- Location: St Petersburg Florida
- Contact:
Re: Blade Tracking LED's
Cannot access your attachment.. says there's an error (am i doing something wrong?)
-
psehorne
- Site Admin
- Posts: 29
- Joined: Tue May 27, 2008 3:04 pm
- Location: Shady Shores, TX, USA
- Contact:
Re: Blade Tracking LED's
Blade tracking L.E.D.s are available from Safari Helicopters http://www.acehelicopter.com/news%20rel ... lights.htm
$90 for 2, $120 for 3
$90 for 2, $120 for 3