rotor/engine rpm guage

[fred]

I am having trouble with my rotor/engine RPM gauge. Every once in a while, the engine RPM needle does not move off zero.

Does anybody know where to send these gauges and for overhaul and what the cost is? Or perhaps there are some used ones for sale.

[9121u]

Fred if you look under parts in the forum here you might find a serviceable one to buy....check your cable also. hope this info helps yea..to get one rebuilt could cost abought 600 or 700 my guess

[Hillberg]

PSI in corona Ca will overhaul or repair it.

[seneca2e]

I sent mine to the outfit below and they did a great job on it. I'm sure others can as well though some are not familiar with the dual tach in a Brantly. Mine was squalling and twitching like a Banshee and it's been flawless since. Make sure the cable is lubed like Tom said. I think it was around $300.

Kelly Instruments
800.835.1054 toll free
4131 May Street
Wichita, Kansas 67209-2838
(316) 945.7171

[fred]

thanks seneca,
I sent mine in to Kelly and they repaired it for me. they were very nice to deal with and the tach is running just fine now.

[seneca2e]

Great to hear you're back up and running fine Fred.