Training

Commerical use and experiences.

Moderator: Paul Sehorne

Post Reply
User avatar
Ron Spiker
Founding Member
Posts: 530
Joined: Sat Mar 22, 2003 5:33 pm
Location: Pittsburgh, PA
Contact:

Training

Post by Ron Spiker »

I had the opportunity to work with a pilot this past weekend who has a Brantly, but hasn't gotten to fly it yet. He has time in several helicopter models, including some in a Brantly, but he wanted to focus on advanced maneuvers and emergency procedures. And that we did, for more than 4 hours.

I started him off easy, with some normal takeoffs and approaches, then maximum performance takeoffs, steep approaches, running takeoffs and landings, no-hover takeoffs and landings, some ground maneuvers, air taxi, quick stops... just getting warmed up. We worked a while on engine failures and tail rotor failures at hover, and hover taxi engine failure. Some of these expected were and several by surprise.

Then autos from altitude. We must have spent 2.5 hours on these. Straight-in, 90°, 180°, 360°, to the left, to the right, adjust for too short or too long. After the first few with power recovery, then almost all the remaining were full touchdown. He was doing so well I started chopping the throttle during takeoff, during steep approaches, anywhere in the pattern, while hovering or hover taxi, and surprise tail rotor failures. Anywhere where I knew it was safe to get into an auto. Most of these were to the ground also.

An intense workout, but enjoyable. Congrats to the pilot. Great job done.
9121u
Posts: 255
Joined: Sat Mar 29, 2003 6:20 pm

Re: Training

Post by 9121u »

GREAT JOB i bet he loved that training ..this type of training every one should go threw ..even just to freshen up on things ..I no i need to get some more of you..glad to here there's still interest in brantlys there going to be around a log time..I think BEST flying helicopter out there.........tom
Post Reply